SYS-FIT Rail Rack Instructions

With each SYS-FIT Rack package ordered, you should receive the SYS-FIT Rail Rack, a set of SYS-GRP M5 Rail Inserts and the required M5 x 0.8mm fasteners.  For a SYS-FIT SMR Rack you should have received 50mm fasteners and if you are using the SYS-FIT SMR + SME Rack combination you should have received 70mm fasteners.  To begin installation you will need the following:

  1. SYS-FIT SMR Rack and optionally the SYS-FIT SME Rack
  2. SYS-GRP M5 Rail Inserts
  3. Supplied M5 fasteners
  4. Screwdriver (not supplied)
  5. 4mm Hex Drive bit or allen wrench (not supplied)
  6. Cup of coffee or other adult beverage

INSTRUCTIONS

  1. To start, simply take the provided M5 fasteners and insert it thru the mounting holes on the SMR Rack.  If you purchased any SYS-FIT ModPods you can mount them to the SMR Rack before or after installation.
  2. If you have the SME Rack as well, align the protruding registration elements on the front of the SME Rack with the recessed registration elements on the back of the SMR Rack
  3. After the fasteners are thru the complete assembly, thread the M5 fastener into the provided SYS-GRP M5 Rail Inserts.  The SYS-GRP M5 Rail Inserts are designed and have been tested to work with most available aluminum extrusion profiles in the market or used in the shop space (see list below).  If for some reason you have an extrusion profile that the provided insert will not fit, please reach out to us.
  4. Once the SYS-GRP M5 Rail Inserts are loosely threaded onto the back of the assembly, insert the rail inserts into the track on your extrusion profile
  5. Slide the assembly to the desired location on the rail and tighten the M5 fasteners with a 4mm Hex Drive Bit or wrench.
  6. Take a drink and populate your new SYS-FIT SMR Rack with all your needed accessories