SYS-GRP FS Rail Vacuum Pods
With each SYS-GRP FS Rail Vacuum pod package ordered, you should received the SYS-GRP FS Rail Vacuum pods, a set of SYS-GRP FS Rail brackets, a set of SYS-GRP M5 Rail Inserts and the required M5 x 0.8mm fasteners, along with 2+ lengths of 1.4" PU Tubing and a set of M4 x 0.7mm fasteners. To begin installation you will need the following:
- SYS-GRP FS Rail Vacuum pods
- SYS-GRP FS Rail brackets
- SYS-GRP M5 Rail Inserts
- Supplied M5 x 0.8mm fasteners
- Supplied M4 x 0.7mm fasteners
- 4mm Hex Drive bit or allen wrench (not supplied)
- 2.5mm Hex Drive bit or allen wrench (not supplied)
- Cup of coffee or other adult beverage
INSTRUCTIONS
- To start, simply take the provided M4 fasteners and attach a SYS-GRP FS Rail brackets to each SYS-GRP FS Rail Vacuum pod
- Once each pod has been affixed to a bracket, take the provided M5 fasteners and insert them thru the mounting holds on the bracket
- Thread the M5 fasteners into the provided SYS-GRP M5 Rail Inserts
- With the first pod and bracket assembly, slide the SYS-GRP M5 Rail Inserts into the outer channel along top of the FS rail
- Repeat step 4 for each additional pod and bracket assembly
- Once you have all of your pod and bracket assemblies on the rail, distribute each assembly in an equal manner along the rail
- Once you have them in the desired location tighten the M5 fasteners with a 4mm Hex Drive Bit or wrench.
- Pause here to take a refreshing drink to prepare for the next steps
- Once your thirst has been quenched, take a section the provided 1/4" PU tubing and insert it into one of pods push to connect fittings, repeat between each pod adjusting the pod spacing if necessary
- After linking each pod to one another take the remaining section of 1/4" PU tubing and insert it into the final pod in the sequence and routing this tubing to the vacuum source of your choice.
- Take another drink of your beverage and prepare to use the SYS-GRP FS Rail Vacuum pods on your desired workpiece