SYS-GRP Grabo Pro-Lifter Adapter Instructions

With each SYS-GRP Grabo Pro-Lifter Adapter ordered, you should receive the SYS-GRP Grabo Pro-Lifter Adapter, a 'Joey' washer and a 'Joey' nut.  To begin installation you will need the following:

  1. SYS-GRP Grabo Pro-Lifter Adapter assembly
  2. Supplied 'Joey' washer
  3. Supplied 'Joey' nut
  4. Grabo Pro-Lifter 20 (not supplied)
  5. 5mm Hex bit or allen wrench
  6. 9/16" socket that will fit in the available Grabo nut location
  7. Cup of coffee or other adult beverage

INSTRUCTIONS

  1. To start, you will need to remove the factory port plug from your Grabo Pro-Lifter 20.  You can do this with a 5mm hex bit or allen wrench and 9/16" socket by flipping your Grabo over to find the nut and loosen, using the hex wrench to keep the bolt from spinning.

  1. Once you've removed the factory plug, thread the factory nut back onto the bolt and keep in the even you would like to remove the Grabo adapter in the future
  2. Remove the supplied 'Joey' nut from the threads of the Grabo adapter 
  3. Make sure the 'Joey' washer is seated well against the bottom of the Grabo adapter (your 'Joey' washer may differ in color than what is pictured)

  1. Insert the Grabo adapter thru the body of the Grabo with the 'Joey' washer on the outside of the vacuum chamber
  2. Thread the supplied 'Joey' nut onto the threads of the adapter

  1. Tighten the nut down to seal the adapter against the Grabo body.  Do not over torque or apply extra 'ugga-dugga' to the nut

  1. Actuate the valve closed on the assembly and place the Grabo on a non-porous surface.  This step is critical to test for any vacuum leaks.
  2. Once you are statisfied there are no leaks you can hook your vacuum work-holding system to the push to connector port on the adapter and open the valve.
  3. Take a drink and enjoy your new mobile vacuum work holding solution

NOTES

  • To use the Grabo to generate a vacuum, place the Grabo on a non-porous surface and activate
  • Once the vacuum work-holding pods or alterntive device has a seal on a work piece you should see the vacuum pressure rise on the Grabo
  • The Grabo may or may not cycle off during use, this is all dependent on both the work piece being held and the surface the Grabo is placed upon.