SYS-MNT Installation Instructions

SYS-MNT - SYS3 Minimus Mounting System

SYS-MNT - SYS3 Minimus is designed to utilize the two (2) supplied SYS-PLT - Systainer3 Mounts.  To mount your new SYS-MNT - SYS3 Minimus to the front of your systainer, first layout all items as shown below, where the tabs are oriented towards the top of the SYS-MNT and flat against your surface

 

After you have everything in the correct orientation, place your SYS-MNT on top of your SYS-PLT elements and align the M4 holes, as shown below

After you have everything aligned, begin treading the supplied M4 flanged screws into the threaded inserts of the SYS-PLT.  Do not completely tighten any of the fasteners until you all fasteners started.

Once you have all eight fasteners started and completely tightened you are ready to install your SYS-MNT - SYS3 Minimus assembly in place.  Align the SYS-PLT tabs with the openings at the top of the card slots on front of your Systainer3, as shown in the photo below.

After you have everything aligned, gently press the SYS-MNT assembly down into the card slot.  You may hear a positive click when you get it seated, but you may only feel resistance when the bottom of the SYS-PLT impacts the lower ledge of the card slots with no audible click.  This completes the standard SYS-MNT - SYS3 Minimums installation.

If you need to install one of our SYS-FIT Racks along with your SYS-MNT, please follow the steps below.

First remove the four (4) M4 flanged screws.  Once removed you can align the SYS-FIT Rack with the treaded insert holes and start a M4 x 10mm Hex Drive Flat Head Screw (supplied if SYS-FIT Rack and SYS-MNT assembly is ordered at the same time)  into the threaded inserts of the SYS-PLT.  Do not completely tighten any of the fasteners until you all fasteners started.

Once all fasteners are started you can tighten them completely.  Your SYS-MNT - SYS3 is now ready for use.

SYS-MNT - TBX Mounting System for M/L series ToolBox

SYS-MNT - TBX is designed to utilize the two (2) supplied SYS-MNT anchors and the existing top holes of your Systainer3 Toolbox to mount to the rear of your toolbox.  To mount your new SYS-MNT - TBX to the rear of your systainer, first insert your two (2) SYS-MNT anchors where they align with the second hole from the outside on both sides.

Insert the anchors under the lip of the toolbox with the F3D logo oriented towards the interior of the toolbox

As you insert the anchors make sure they aligned with the second hole in from the outside and the F3D logo is oriented toward the interior of the toolbox

Once you have the anchors in place you can align the SYS-MNT TBX Mounting system to the anchors and begin threading the supplied M6 flanged bolts thru the SYS-MNT and into the anchors.  Do not completely tighten the fasteners until you both fasteners started.

After both bolts have been tightened your SYS-MNT TBX should look like this.

You can begin attaching SYS-FIT Racks or other accessories to your SYS-MNT TBX Mounting system immediately for use.